Canon C100 Manuel d'instructions télécharger pdf (Page 154)

Browser Remote: Controlling the Camcorder from a Network Device

154

3 Select [On] and then press the joystick.

• will appear on the top of the screen. When the icons turn white, the camcorder is ready to accept

commands from the Browser Remote application.

• With Camera Access Point connections, you need to actively connect the Wi-Fi enabled device to the

camcorder.

4 Check the camcorder’s IP address on the status screen.

• Press the STATUS button to open the status screens and push the joystick up/down to select the [Network

Settings 4/9] status screen.

• Check the IP address assigned to the camcorder ([IP Address]) and, if necessary, write it down.

• Press the STATUS button to close the status screen.

On the Connected Network Device

1 Start the Web browser on the network device.

2 Enter the camcorder’s URL and start the Browser Remote application.

• Enter the IP address you checked previously into the Web browser’s address bar, adding the prefix “http://”.

• If you chose a port other than the default port [80], you can specify it by adding “:nnn” at the end of the URL.

For example “http://192.168.0.80:095”.

• The Browser Remote screen will appear.

• While the device is connected, the network connection indicator (‹‹‹‹) will repeatedly illuminate and go

out.

3 Check the camcorder’s ID.

• The camcorder’s ID will appear on the Browser Remote screen while live view is not activated. It will not

appear if the camcorder's ID has not been set.

Language selection

Camcorder ID

Network connection

indicator

Screen selection tabs appear only for [Full Control User]

COPY

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 213 214

Pas de commentaire

Canon C100 Manuel d'instructions Page 154