Canon PIXMA MG2550S Manuel d'utilisateur télécharger pdf (Page 114)

Changing the Machine Operation Mode

If necessary, switch between various modes of machine operation.

The procedure for configuring Custom Settings is as follows:

1. Make sure that the machine is on, and then select Custom Settings

from the pop-up menu on the Canon IJ Printer Utility

Note

If the computer is unable to communicate with the machine, a message may be

displayed because the computer cannot access the function information that was

set on the machine.

If this happens, click Cancel to display the most recent settings specified on your

computer.

2. If necessary, complete the following settings:

Ink Drying Wait Time

You can set the length of the machine rest time until printing of the next page begins.

Moving the slider to the right increases the pause time, and moving the slider to the

left decreases the time.

If the paper gets stained because the next page is ejected before the ink on the

printed page dries, increase the ink drying wait time.

Reducing the ink drying wait time speeds up printing.

Align heads manually

Usually, the Print Head Alignment function of Test Print on the pop-up menu in the

Canon IJ Printer Utility is set to automatic head alignment, but you can change it to

manual head alignment.

If the printing results are unsatisfactory even after you execute automatic head

alignment, execute manual head alignment.

Check this check box to perform the manual head alignment. Uncheck this check box

to perform the automatic head alignment.

3. Apply the settings

Click Apply and when the confirmation message appears, click OK.

The machine operates with the modified settings hereafter.

114

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 402 403

Pas de commentaire

Canon PIXMA MG2550S Manuel d'utilisateur Page 114