2.4 Interface Specifications
2.4.1 Parallel interface
1) Interface type
IEEE 1284 parallel interface
2) Data transfer method
8-bit parallel transfer (Compatibility mode and nibble mode supported)
3) Signal level
Input
“Low” level: 0.0 V to +0.8 V
“High” level: +2.0 V to +5.0 V
Output
“Low” level: 0.0 V to +0.4 V
“High” level: +2.4 V to +5.5 V
4) Input/Output
+5 V pull-up for all signals
5) Interface cable
Cable: Twisted-pair, double-shielded cable, 2.0 m or shorter
Must conform to IEEE 1284.
Wire material: AWG (American Wire Gauge) No. 28 or higher
6) Interface connector
On printer: Amphenol 57-40360 or equivalent
On cable: Amphenol 57-30360 or equivalent
7) I/O signal and pin array
For details, see
“Part 5: CONNECTOR LOCATION AND PIN ARRAY” on page 5-13
.
2.4.2 Serial interface
1) Interface type
USB (Universal Serial Bus conforming to USB Specification Revision 1.0)
2) Data transfer method
Control transfer
Bulk transfer
3) Signal level
-Data, +Data
Difference input sensitivity: +0.2 V (Min.)
“H” level output voltage: +2.8 V to +3.6 V
“L” level output voltage: +0.0 V to +0.3 V
Vcc
“H” level input voltage: +2.0 V to +5.5 V
“L” level input voltage: +0.0 V to +0.8 V
4) Input/Output
3.3 V pull-up for +Data signal
5) Interface cable
Cable: Twisted-pair, shielded cable, 5.0 m or shorter
Must conform to USB.
Wire material: AWG (American Wire Gauge) No. 28 or higher
6) Interface connector
On printer: USB with series-B receptacle
On cable: USB with series-B plug
7) I/O signal and pin array
For details, see
“Part 5: CONNECTOR LOCATION AND PIN ARRAY” on page 5-13
.
1-7
LR1
Part 1: Product Outline
Commentaires sur ces manuels