Canon imagePROGRAF iPF750 Basic guide No.3 Manuel d'utilisateur Page 709

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 742
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 708
Messages regarding paper
Paper size not detected.
Cause Corrective Action
Follow these steps to reload the roll.
1. Push the Release Lever back.
2. Adjust the right edge of the roll to make it parallel
to the orange Paper Alignment Line .
3. Pull the Release Lever forward.
4. If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
( P .106)
If this error recurs after you reload the roll, remove
the Roll Holder from the printer , push the roll rmly in
until it touches the Roll Holder ange, and reload the
Roll Holder in the printer .
( P .103)
Paper has been loaded askew , or warped paper has
been loaded.
Follow these step to reload a sheet.
1. Push the Release Lever back.
2. Load the sheet, aligning it with the guide on the
right.
3. Pull the Release Lever forward.
4. If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
( P .136)
Because the Platen is soiled with ink or other
substances, the size of the clear lm cannot be
detected.
Open the T op Cover and clean the entire Platen .
( P .647)
Error Message 693
Vue de la page 708
1 2 ... 704 705 706 707 708 709 710 711 712 713 714 ... 741 742

Commentaires sur ces manuels

Pas de commentaire