69 Projector Control
Projector Control
Control Commands
You can control this projector by sending commands via CONTROL port or LAN port.
System Requirement
CONTROL port
TCP/IP Connection
Control Command
RS-232C HDBaseT LAN
Connection Cable Dsub9
RJ45(CAT5e or
better)
RJ45
Communication Mode
RS-232-C asynchronous, half-duplex
communication
TCP/IP
Baud Rate 19200 9600
Character Length 8 bit
Parity Check None
Stop Bits 1 bit
Flow Control None
Port
WEB:80
Control command?Telnet?:33336
CrestronControl:41794
FLASH UI:843
Function
Read/
Write
Operation Command (ASCII) Note
Product
R Model Name[1] GET=PRODCODE<CR>
R MAC Address GET=PRODSN<CR>
Power
W Power On POWER=ON<CR>
Enable during
“Standby” state.
W Power Off POWER=OFF<CR>
R Power Status GET=POWER<CR>
Enable during any
power state.
[Warming up]
g:POWER=OFF2ON
[Cooling down]
g:POWER=ON2OFF
Commentaires sur ces manuels