Canon LX-MU500Z Manuel d'utilisateur télécharger pdf (Page 34)

34 Operation

Operation

Starting up the projector

1. Plug the power cord into the projector and into a wall

socket. Turn on the wall socket switch (where fitted).

Check that the POWER indicator light on the

projector lights orange after power has been applied.

2. Press on the projector or remote control to start the projector. The power indicator

flashes green and stays green when the projector is on.

(If necessary) Rotate the focus ring to adjust the image clearness.

3. If the projector is activated for the first time, select your OSD language following the

on-screen instructions.

4. If you are prompted for a password, press the arrow keys to enter a 6-digit password. See

"Security Settings" on page 50.

5. Switch all of the connected equipment on.

6. The projector will search for input signals. The current input signal being scanned appears.

If the projector does not detect a valid signal, the message “No Signal” will continue

displaying until an input signal is found.

You can also press INPUT to select your desired input signal. See "Switching input signal"

on page 35.

• Ask your installation specialist to provide an Earth

leakage breaker. When you do not use the projector,

be sure to shut down the main power by the breaker.

• Please use the original accessories (e.g. power cord)

only with the device to avoid possible dangers such as

electric shock and fire.

• In order to ensure the safety in case of trouble with

the projector, use an electrical outlet having an earth

leakage breaker to supply the power to the projector.

If you do not have such outlet, ask your dealer to

install it.

• If the projector is still hot from previous activity, it will run the cooling fans for approximately 90

seconds before energizing the light source.

• To maintain the light source life, once you turn the projector on, wait at least 5 minutes before

turning it off.

• After POWER is pressed, the image may flicker before the light source becomes stable. This is

not a product malfunction.

If the frequency/resolution of the input signal exceeds the projector's operating range, you will see

the message “Out of Range” displayed on the background screen. Please change to an input

signal which is compatible with the projector's resolution or set the input signal to a lower setting.

See "Timing chart" on page 64.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 72 73

Pas de commentaire

Canon LX-MU500Z Manuel d'utilisateur Page 34