CHAPTER 3
3 - 12
C. DC Controller PCB
1 . Removing the DC controller PCB
The following is an outline of the work flow
used to disassemble/assemble PCBs:
Note: The number within parentheses in-
dicates the number of screws used.
Printer
Upper cover (2)
Extension board
slot cover (1)
Slot cover (2)
(hard disk installed)
Hard disk (2)
(option installed)
Left cover (1)
Right cover (1)
Video controller
PCB unit (4)
Rear cover (9)
Multifeeder tray
power supply
switch rod
Printer top unit
(6 on left + 7 on right)
DC controller
PCB(5)
Power supply PCB (7)
Cassette
Front cover
Cartridge
Figure 3-2-17
1) Remove the multifeeder tray. (See IV-B-
1 ‘Removing the Multifeeder Tray.’)
2) Remove the video controller PCB unit.
(See II-B-1 ‘Removing the Video Control-
ler PCB unit.’)
3) Disconnect the connector [1] from the
power supply PCB and the 9 connectors
[2] from the DC controller PCB.
[1]
[2]
[2]
[2]
[2]
[2]
Figure 3-2-18
4) Free the harness [3] from the harness
guide [4].
[3]
[4]
Figure 3-2-19
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
Commentaires sur ces manuels