Canon iPF6000S Manuel d'utilisateur Page 689

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 730
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 688
Cannot print over a network
Cannot print over a TCP/IP network
Cause Corrective Action
The printer s IP address is not congured correctly . Make sure the printer s IP address is congured
correctly .
( P .432)
( P .470)
The printer s TCP/IP network settings are not
congured correctly .
Make sure the printer s TCP/IP network settings are
congured correctly .
( P .473)
The computer you are trying to print from is not
congured correctly .
Make sure the computer s TCP/IP network settings
are congured correctly .
( P .481)
( P .501)
Cannot print over a NetW are network
Cause Corrective Action
The printer s NetW are settings are not congured
correctly .
Make sure the printer s NetW are settings are
congured correctly . In particular , make sure a valid
frame type is selected. For details, see “Conguring
the Printer s NetW are Network Settings”. (→P .476)
The computer you are trying to print from is not
congured correctly .
Make sure the computer s NetW are settings are
congured correctly . For details, see “Conguring
NetW are Network Settings”. (→P .493)
The NetW are server and services are not congured
correctly .
Check the following points.
1. Make sure the NetW are le server is running.
2. Make sure there is enough free disk space on the
NetW are le server . Insuf cient disk space may
prevent you from processing large print jobs.
3. Start NW ADMIN or PCONSOLE and conrm that
the print service is congured correctly and the
print queue is available.
4. If data transmission to a printer on another subnet
fails, deactivate NCP burst mode in that printer s
network protocol settings.
5. If the printer is used in queue server mode, specify
“Other/Unknown” as the printer type.
The printer was turned of f and on when not
disconnected from the server .
Leave the printer of f for at least 30 seconds, and
then restore power .
T roubleshooting 675
Vue de la page 688
1 2 ... 684 685 686 687 688 689 690 691 692 693 694 ... 729 730

Commentaires sur ces manuels

Pas de commentaire