Canon EOS C500 Manuel d'utilisateur télécharger pdf (Page 88)

Synchronizing with an External Device

Using genlock synchronization, you can synchronize this camera’s video signal to that of an external video

device. Similarly, using an external time code signal, you can synchronize this camera’s time code to the external

signal. Using the external time code signal with multiple cameras allows you to set up a multi-camera recording.

You can also output the time code signal from this camera to achieve the same result. If you output the time

code (while shooting) from the 3G-SDI terminals or HD/SD SDI terminal* to an editing device, the editor can

create video with the same time code.

* The HD/SD SDI terminal can also output the time code during playback.

Connecting an External Device

When synchronizing the camera to an external signal, input a reference video signal* through the GENLOCK

terminal or output the camera’s signal as a reference signal for an external device through the SYNC OUT terminal.

When synchronizing a time code signal, use the TIME CODE terminal. Be sure to set the TIME CODE terminal to

input or output in advance.

Connect the external device to the camera as shown in the following diagram.

* For the reference video signal, you can use an analog blackburst or tri-level signal.

Connection Diagram

Reference Video Signal Input (Genlock Synchronization)

When a reference sync signal (analog blackburst or tri-level signal) is input through the GENLOCK terminal, the

phases of the camera’s V and H sync will automatically be synchronized to it. The phase difference between the

external Genlock signal and the camera is initially set to 0. The H phase can be adjusted within the range of

approximately ±0.4 H (HD equivalent).

1 Open the [Genlock Adjust.] submenu.

[w Other Functions] > [Genlock Adjust.]

2 Adjust the phase to the desired level, select [Set] and then press

SET.

• Use the joystick (Ý) or SELECT dial to select the value for each field

and press SET to move to the next field.

Operating modes:

SYNC OUT terminal

TIME CODE terminal

GENLOCK

synchronization

Time code

synchronization

GENLOCK terminal

[w Other Functions]

[Genlock Adjust.]

COPY

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 209 210

Pas de commentaire

Canon EOS C500 Manuel d'utilisateur Page 88