Canon Elura 65 Manuel d'utilisateur télécharger pdf (Page 144)

144

Condensation

Moving the camcorder rapidly between hot and cold temperature may cause

condensation (water droplets) to form on its internal surfaces. Stop using the

camcorder if condensation is detected. Continued use may damage the camcorder.

Condensation may form in the following cases:

How to avoid condensation:

❍ Unload the cassette, place the camcorder in an airtight plastic bag and let it adjust

to temperature changes slowly before removing it from the bag.

When condensation is detected:

❍ The camcorder stops operating and the warning message “CONDENSATION HAS

BEEN DETECTED” appears for approx. 4 seconds and h starts flashing.

❍ If a cassette is loaded, the warning message “REMOVE THE CASSETTE” appears and

v starts flashing. Remove the cassette immediately and leave the cassette

compartment open. Leaving the cassette in the camcorder may damage the tape.

❍ A cassette cannot be loaded when condensation is detected.

Resuming use:

❍ It takes about 1 hour until the water droplets evaporate. After the condensation

warning stops flashing, wait for 1 more hour before resuming use.

When the camcorder is moved from an

air-conditioned room to a warm, humid

place

When the camcorder is moved from a

cold place to a warm room

When the camcorder is left in a humid

room

When a cold room is heated rapidly

8_D82NTSC_E(135-161) 1/30/04 14:44 Page 144

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 161 162

Pas de commentaire

Canon Elura 65 Manuel d'utilisateur Page 144