Canon Powershot SD430 Guide d'installation télécharger pdf (Page 105)

101

"Connection failed 2" and "Connection failed 3" Message

Cause

Wireless network settings are incorrect. The registration of the target

device on the camera may have failed.

Solution 1:

Attach the camera to the computer with the interface cable and check the

following settings for the target device.

[Network Name (SSID)]

[Network Authorization - Encryption]

Solution 2

If you configured the connection in the [Simple Mode], select the [Advanced

Mode] as described in Step 8 of Registering the Target Device with the

Camera (p. 80) and reregister the computer with the camera.

• An IP address is a unique identifying number assigned to a device, such

as a camera or computer, connected to a network.

• A DHCP (dynamic host configuration protocol) server is a server

computer that issues IP addresses to cameras or computers on the

network.

How to Check the Registration Information

Perform steps 1-7 in Registering the Target Device with the Camera (p. 78), continue

with the procedures below and check the registration information.

Also use the above windows to confirm that the information recorded in the checklist

(p. 77) is correct.

Place a check mark in the box for [Change

registered information in camera].

Check the

camera's MAC

address here.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 129 130

Pas de commentaire

Canon Powershot SD430 Guide d'installation Page 105