Canon DC20 E Spécifications télécharger pdf (Page 171)

DC10 E, DC20 E

SERVICE HINTS

2. Troubleshooting

To detect the defective parts for repair, if any, use the following hints and check points.

2-1 Power Supply Malfunction

<Hints>

When the power source is attached, the unit enters the standby mode in the following sequences.

Main power is connected. → UNREG is supplied to the MAIN PCB → SUB MI-COM starts up. → CCM MI-COM starts up. → SUB

MI-COM outputs VCR ON “H” signal. → PWM driver starts up and turns on each power supply. → Establishes communication with

the BACK END → The CCM MI-COM is brought into standby status with the VCR ON changed to VCR Low.

After that, the power supply is turned ON by the following procedures.

Power supply mode switch operation → After received by MODE MI-COM, VCR ON “H” is output. → The PWM driver is starts to

turns on various power supplies. → The MI-COM in the BACK END is started up to control the system.

1) Key Input

Check the key input at Power Switch in service mode.

2) Check of microcomputer-to-microcomputer communication

If the microcomputer-to-microcomputer communication line is normal, the version number of each microcomputer will be dis-

played in service mode. Otherwise, the communication line or microcomputer may be faulty.

3) Fuses on the power supply PCB

Check the continuity of the fuses FU3200, 3201, 3202, 3203, 3204, 3205 and 1800 on the MAIN PCB. If NG, replace the fuse and

check the power consumption. (FU3200 is for DC20 E only.)

4) Replace the MAIN PCB with a service part and check the operation.

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 205 206

Pas de commentaire

Canon DC20 E Spécifications Page 171