Canon MR-14EX II Manuel d'instructions télécharger pdf (Page 37)

q: Manual FlashN

When using an EOS-1D series camera, the flash exposure level can be

manually set before shooting. This is convenient for shooting at a short

distance from the subject. Use a 18% gray reflector (commercially

available) and shoot as follows.

1 Configure the camera and MR-14EX II settings.

Set the camera’s shooting mode to <a> or <f>.

Set the MR-14EX II’s flash mode to <a>.

2 Focus on the subject.

Focus manually.

3 Set up an 18% gray reflector.

Place the gray reflector at the subject’s position.

Aim the camera so that the entire spot metering circle at the

viewfinder center is over the gray reflector.

4 Press the <B>, <P>, or <7> button. (8)

X The MR-14EX II will fire a preflash and the required flash output

for the correct flash exposure is retained in memory.

X On the right side of the viewfinder, the exposure level indicator

will show the flash exposure level against the standard exposure.

5 Set the flash exposure level.

Adjust the MR-14EX II’s manual flash level and the

aperture so that the flash exposure level aligns with

the standard exposure index.

6 Take the picture.

Remove the gray reflector and take the picture.

Metered Manual Flash Exposures

Metered manual flash exposure is available only with EOS-1D series

cameras.

COPY

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 259 260

Pas de commentaire

Canon MR-14EX II Manuel d'instructions Page 37