Canon 580EXII Manuel d'instructions Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 62
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
Turning on the Power Switch
,II
11111
III
1111
111111111111111
\1
Set the power switch to <ON>.
l'"
The flash recycling starts.
Check that the flash
is
ready.
The pilot lamp will first turn green (ready
for quick flash),
then
red
(flash ready).
Pressing the pilot lamp will fire a test
flash.
About Quick Flash
Quick flash enables a flash to be fired before flash-ready, when the pilot
lamp
is
still green.
Although the Guide
No.
will
be
1/6 to 1
/2
that of the full output, quick flash
is
effective for near subjects and when you want a shorter recycle time.
Set the drive mode to single shooting. Quick flash cannot be used in the
continuous shooting, FEB, manual flash, and stroboscopic flash modes.
[IliI
Quick flash can also
be
used during continuous flash shooting.
(C.Fn-06
~
p.27)
About Auto Power Off
To
save battery power, the power will turn off automatically after a
certain period (approx. 1.5 min. to 15 min.)
of
idle use.
To
turn on the
Speedlite again, press the camera's shutter button halfway.
Or
press
the Speedlite's test firing button.
[IliI
Auto Power Off can also
be
disabled. (C.Fn-01
~
p.27)
[lJ
A test flash cannot be fired while the camera's operation timer 04 or 06
is
active.
The Speedlite's settings will be retained
in
memory even after the power
is
turned off.
To
retain the Speedlite's settings after you replace the
batteries, turn off the power and replace the batteries within 1 minute.
10
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 61 62

Commentaires sur ces manuels

Pas de commentaire