Canon RE-450X Manuel d'instructions télécharger pdf (Page 12)

POWER

Turn the power ON.

When the power of the RE-450X is turned ON, the POWER

indicator on the operation panel lights up.

Turn ON the power source of the other equipment to be used.

Either the power of the RE-450X or other equipment may be turned on first.

Put the document at the center of the document

table.

If no image is displayed, check to see that the lens cap has been

removed.

POWER

The power of the RE-450X should be turned OFF when the unit is not used.

Disconnect the power cord if the unit will not be used for extended periods.

• When the power is turned on, it takes about 20 seconds to

show an image.

• When the power is turned on, white balance and focus are

automatically adjusted.

When operation is completed, turn the power

OFF.

The POWER indicator goes off. The illumination lamps or

backlight will go off (if they are on). Also turn OFF the power of

other equipment.

After turning the power OFF, wait at least 5 seconds before

turning the power ON again. Turning the power ON too soon

may cause a malfunction.

Document table

Power switch Operation Panel

OPERATION

NOTICE

RE-450X_E 01.10.24 22:15 ページ 11

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Pas de commentaire

Canon RE-450X Manuel d'instructions Page 12